Honda 37830-RNA-A01 Sensor Assembly, Map

You can Select Your Vehicle to check if 37830-RNA-A01 fits your vehicle.

The MAP sensor is located on the intake manifold, near the throttle body for four-cylinder models and on top of the throttle body for V6 models. To remove the MAP sensor from a four-cylinder engine, first disconnect the electrical connector from the MAP sensor. This can be done by depressing the release tab and disconnecting the electrical connector, then removing the sensor retaining screw. Next, remove the MAP sensor retaining screw and the MAP sensor itself. Be sure to remove and discard the old MAP sensor O-ring. Always use a new O-ring when installing the MAP sensor, whether you're installing the old sensor or a new unit. The installation process is the reverse of removal, and it's important to use a new O-ring. For V6 models, the process is the same. Disconnect the electrical connector from the MAP sensor, remove the MAP sensor retaining screw and the sensor, and remove and discard the old MAP sensor O-ring. Again, installation is the reverse of removal, and a new O-ring should be used.