Honda 51401-TK6-A12 Spring, Front

You can Select Your Vehicle to check if 51401-TK6-A12 fits your vehicle.

Place the strut mounting cushion onto the strut and guide the unit into place, install the strut mounting base, washer and upper mounting nut, install new strut-to-knuckle bolts and nuts, raise the front suspension with a jack to load the strut with the vehicle weight, then tighten the strut-to-knuckle bolts and nuts to the torque, connect the stabilizer bar link to the strut and tighten the nut to the torque, hold the strut piston rod with an Allen wrench and tighten the strut upper mounting nut to the torque, install the wheel and lug nuts, then lower the vehicle and tighten the lug nuts to the torque, have the front end alignment checked and, if necessary, adjusted.

Loosen the rear wheel lug nuts, raise the rear of the vehicle, support it securely on jackstands and remove the wheels. Position a floor jack under each coil spring seat portion of the rear suspension beam, then raise the jacks slightly. Remove both shock absorber lower mounting bolts. On 2009 and later models, remove the wheel speed sensor and wire harness retainer from both sides of the axle beam. Carefully lower the floor jacks until the coil springs are fully extended. Remove the coil spring, the rubber mount and the rubber seat. Installation is the reverse of removal, noting the following points: Replace rubber components if they are deteriorated. Replace the shock absorber lower mounting bolts with new ones. Raise the trailing arm portions of the rear axle with the floor jacks until each side is at normal ride height, then tighten the shock absorber lower mounting bolts to the torque. Install the wheels and lug nuts. Lower the vehicle and tighten the lug nuts to the torque.

If the lower insulator is being replaced, set it into position with the dropped portion seated in the lowest part of the seat, extend the damper rod to its full length and install the dust boot, place the coil spring onto the lower insulator, with the end of the spring resting in the lowest part of the insulator, install the upper insulator and the spring seat, install the upper spring seat and the strut bearing, install the strut piston rod nut and tighten it to the torque, remove the spring compressors, install the mounting base on the strut, then install the strut coil spring assembly.