Honda 53200-SLN-A01 Column Assembly, Steering

You can Select Your Vehicle to check if 53200-SLN-A01 fits your vehicle.

Disconnect the cable from the negative terminal of the battery, set the wheels in the straight ahead position (on 2009 and later models, tilt the steering all the way up and push it all the way in), remove the steering wheel, remove the under-dash panel, remove the cover from the U-joint at the bottom of the steering column shaft (remove the plastic retainers and take off the steering column U-joint cover) (on 2009 and later models, hold the lower shaft on the column with a a length of wire or suitable fastener between the lower U-joint yoke and the upper shaft to prevent the slide shaft from pulling out, release the Jocking lever and slide it all the way out and tighten the lock lever), remove the steering column covers, disconnect the electrical connectors from the combination switch and the airbag clockspring, remove the combination switch, disconnect the ignition switch electrical connectors and detach the harness clips, mark the U-joint to the steering column shaft (2007 and 2008 models) and to the steering gear pinion shaft, then remove the U-joint pinch bolt(s) and disconnect the U-joint from the steering gear pinion shaft, remove the column mounting bolts (lower) and nuts (upper), guide the column out from the instrument panel, remove the plastic center installation guide (if equipped) from the steering gear pinion shaft or the steering column U-joint and discard it (this part will not be re-used as it was for factory installation purposes only), installation is the reverse of removal, reconnect the battery.