Honda 53200-T0A-A01 Column Assembly, Steering

You can Select Your Vehicle to check if 53200-T0A-A01 fits your vehicle.

Park the vehicle with the wheels pointing straight ahead, disconnect the cable from the negative terminal of the battery, adjust the steering wheel tilt to the Neutral position approximately 8 mm down from the uppermost position, remove the steering wheel, steering column covers, driver's knee bolster, clockspring, steering column switches, steering column joint cover, mark the relationship of the steering shaft U-joint to the steering gear input shaft, then remove the pinch bolt, collapse the intermediate shaft enough to free the splines, tie or tape the shaft so that it cannot slide apart, remove the steering column mounting fasteners, lower the column and pull it to the rear, making sure nothing is still connected, then remove the column, guide the steering column into position, install the steering column mounting fasteners and tighten them, connect the U-joint to the intermediate shaft, install the intermediate shaft pinch bolt and nut, tightening it, and reconnect the negative battery cable.