Honda 53540-SLN-A01 End, Tie Rod

You can Select Your Vehicle to check if 53540-SLN-A01 fits your vehicle.

Loosen the front wheel lug nuts. Raise the front of the vehicle, support it securely on jackstands, then remove the front wheel. Loosen the jam nut enough to mark the position of the tie-rod end in relation to the threads. Remove the cotter pin (2007 and 2008 models) or lock pin (2009 and later models) and loosen, but don't remove, the nut on the tie-rod end ballstud, then disconnect the tie rod end from the steering knuckle arm with a puller. Remove the nut and separate the tie-rod end from the steering knuckle. Unscrew the tie-rod end from the tie-rod. Thread the tie-rod end on to the marked position and insert the tie-rod end stud into the steering knuckle arm. Tighten the jam nut securely. Install the tie-rod end-to-steering knuckle nut and tighten it to the torque. Install the lock pin (2009 and later models) or a NEW cotter pin (2007 and 2008 models). Install the wheel and lug nuts. Lower the vehicle and tighten the lug nuts to the torque. Have the wheel alignment checked and, if necessary, adjusted.