Honda 17045-S0X-A32 Module Assembly, Fuel Pump

You can Select Your Vehicle to check if 17045-S0X-A32 fits your vehicle.

Here's what you should do:1. Connect the fuel pressure gauge to the fuel system.2. Reconnect the battery.3. Turn the ignition switch to ON.4. Start the engine.

Detach the cable from the negative battery terminal. Relieve the fuel system pressure. Remove the second-row seats, then remove the carpet from the area underneath. Remove the fuel pump access cover screws and remove the fuel pump access cover. Disconnect the fuel pump/fuel level sending unit electrical connector. Disconnect the quick-connect fittings for the fuel supply and return lines and set the fuel lines aside. Remove the fuel pump/fuel level sending unit locknut. This is the special Honda tool for loosening and tightening the fuel pump/fuel level sending unit locknut; if you can obtain one, this is the way to go because it won't damage the plastic locknut. If you're unable to obtain the special Honda tool, you can use a large pair of water pump pliers. Remove the fuel pump/fuel level sending unit module from the tank. Carefully inspect the condition of the seal around the top of the module; if the seal is cracked, torn or deteriorated, replace it. When installing the fuel pump/fuel level sending unit module, install the seal in the hole first. Don't try to install it with the module, which might cause it to become pinched or distorted. Installation is otherwise the reverse of removal. Be sure to tighten the module locknut securely. You can use a torque wrench and tighten the locknut. Reconnect the cable to the negative terminal of the battery.

Reconnect the cable to the negative battery terminal, start the engine and check for fuel leaks at the pump fuel line connections. If there are no leaks, install the access cover, the carpet and the second-row seat.