Honda 51401-SWA-C03 Spring, Right Front

You can Select Your Vehicle to check if 51401-SWA-C03 fits your vehicle.

Remove the strut and spring assembly, mount the strut assembly in a vise, install the spring compressor on the spring and compress it sufficiently to relieve all pressure from the upper spring seat, hold the damper rod with an Allen wrench, and unscrew the damper rod nut with a box-end wrench, remove the nut and upper mount, remove the upper spring seat and insulator from the damper rod, carefully lift the compressed spring from the assembly, remove the dust cover plate and dust cover, slide the rubber bump stop off the damper rod, extend the damper rod to its full length and install the rubber bump stop, dust cover and dust cover plate, carefully place the compressed coil spring onto the lower seat of the damper, install the upper insulator and spring seat, install the bearing and suspension support, install the washer and damper rod nut and tighten it, remove the spring compressor tool, and install the strut/spring assembly.

After securing the vehicle on jackstands and blocking the front wheels, proceed to remove the rear wheel.