Honda 54315-SR2-981 Wire, Control

You can Select Your Vehicle to check if 54315-SR2-981 fits your vehicle.

Remove the center console. Put the shift lever in the Neutral position, then remove the retaining clip from the cable adjuster. Unbolt the shift cable bracket. Unbolt the shift cable holder from the floorpan. Remove the shift cable cover. Remove the control lever from the control shaft, then remove the shift cable. Be careful not to bend the cable when removing or installing it. Installation is the reverse of removal. Be sure to adjust the shift cable when you're through. If not already done, remove the center console. Shift to the Neutral position, then remove the retaining clip from the cable adjuster. There are two holes in the end of the shift cable. They're positioned 90-degrees apart to allow cable adjustments in 1/4-turn increments. Verify that the hole in the adjuster is perfectly aligned with the hole in the shift cable. If the two holes aren't perfectly aligned, loosen the locknut on the shift cable and adjust it as required, then retighten the locknut. Install the retaining clip on the adjuster. If the clip feels as if it's binding as you reinstall it, the cable is still out of adjustment and must be readjusted. Start the engine and check the shift lever in all gears. If any gear doesn't work properly.