Honda 8-97106-130-0 Cable, Engine Hood Control

Before working on the models 1998 or later Amigo, first draw a line on the latch as a guide, then disconnect the bolts that keep the latch in place on the radiator support. Rephrase the following sentence. Keep the sentences direct, flowing, and easy to understand. Also normalize verbalization when possible. Undo the hood release cable connection by sliding out its fixture from the back side of the latch assembly. Reverse the steps used when removing the latch to install the hood mechanism: make sure the latch works well while the bumpers are comfortably squished together. Then, put stiff wire at the cable's end and follow it back to the firewall, dismantling all holding clips along the way. Step into the passenger area and pull the hood release lever, unfastening any mounting screws around it. Detach the cable from the lever's rear compartment, where the connection occurs. You can change the lock cylinder by taking out a cover panel and unscrewing the mounting screws. Give the cable and grommet a lift through the passenger area until you can see the wire, making sure the new cable also has a grommet ready when you connect it. Reach into the engine bay, pull the cable through to the passenger side, and press on the grommet in the passenger's space to fit it right. End your installation process by following the backward steps you used to take everything apart.