Honda 72110-SH2-A22 Lock Assembly, Right Front Door Lock

First of all, one has to take out the door panel, as well as the sealing screen. Then, to remove the lock cylinder from the rod, turn the resin clip counterclockwise. Remove the nuts that lock the outer handle of the door, so that the handle could be removed. Take out the screws that secure the interior door handle and the door lock and take out the door lock mechanism from inside the door. To do this remove the retaining clip and pull out the lock cylinder. Next to install the lock cylinder and the clip back into the door step. Subsequently fit the door lock assembly and the handles. Last of all and very important, screw the door panel with other components that belongs to it.

The power door locking system comprises switches, actuators, and relays, with control switches operating the system. Actuators raise and lower the door lock buttons and are mounted inside the door assembly, functioning electrically when the switch is pressed. A control unit or functional relay regulates current and aligns all actuators and switches. For removal and installation of the door lock switch, first disconnect the negative battery cable, then remove the door panel retaining screws, lift the door panel, and disconnect all necessary electrical connections before removing the panel and switch assembly. Installation follows the reverse order. For the door lock actuator, begin by disconnecting the negative battery cable, removing the door panel, disconnecting the actuator electrical connector and linkage rods, and removing the actuator assembly retaining screws before taking out the actuator assembly. Installation is again the reverse of removal.