Honda 16015-SDC-E00 Regulator Assembly

You can Select Your Vehicle to check if 16015-SDC-E00 fits your vehicle.

Remove the fuel pump/fuel gauge sending unit and place it on a clean workbench. Remove the clip that secures the fuel pressure regulator to the fuel pump/fuel gauge sending unit and pull the regulator out of the fuel pump/fuel gauge sending unit. Note the sleeve that fits over the O-ring end of the regulator. This sleeve must be installed in the correct location for the regulator to fit tightly into the fuel pump/fuel gauge sending unit. Remove and discard the two old fuel pressure regulator O-rings. Installation is the reverse of removal. Be sure to use a pair of new 0-rings and don't forget to install the sleeve.SULEV four-cylinder models and all V6 models: Remove the fuel pump/fuel gauge sending unit and place it on a clean workbench. Remove the holder (To detach the fuel pressure regulator holder from the fuel pump, depress these two lugs, disengage them from the locking tabs on the pump assembly and pull off the holder(SULEV four-cylinder models and all V6 models)). Remove the fuel pressure regulator from the fuel pump/fuel gauge sending unit (To remove the fuel pressure regulator from the fuel pump/fuel gauge sending unit, grasp it firmly and pull it straight out (SULEV four-cylinder models and all V6 models)). Remove and discard the old fuel pressure regulator O-ring. Installation is the reverse of removal. Be sure to use a new O-ring. Coat the O-ring with a little clean engine oil to protect it from kinking or pinching during installation of the regulator.