Honda 17045-SHJ-A51 Set, Fuel Pump Module

You can Select Your Vehicle to check if 17045-SHJ-A51 fits your vehicle.

Detach the cable from the negative battery terminal.

On 2005 and later models, the fuel pump module also contains the fuel pressure regulator. Relieve the system fuel pressure, then disconnect the cable from the negative battery terminal. Remove the fuel pump/fuel level sending unit from the fuel tank. Place the fuel pump/fuel level sending unit module on a clean workbench. Disconnect the return hose from the case. Disconnect the electrical connectors for the fuel pump and for the fuel level sending unit. Separate the bracket and the case. Disconnect the ground wire from its terminal on the side of the fuel filter housing. Disconnect the fuel filter outlet tube from the fuel filter housing. Remove the pump retainer. Remove the rubber isolator. Separate the fuel pump from the fuel filter housing. If you're simply replacing the fuel filter, no further disassembly is necessary. However, we strongly recommend cleaning the fuel inlet strainer and replacing the fuel filter inlet and outlet 0-rings. Remove the fuel inlet sock (strainer) from the fuel pump. Remove the fuel level sending unit from the case. On 2005 and later models, remove the fuel pressure regulator by pulling the retaining clip from the regulator housing. Remove the pressure regulator, its support ring and 0-rings. Replace the O-rings with new ones upon assembly. Before reassembling the fuel pump, fuel filter and fuel level sending unit, wash the fuel strainer thoroughly in clean solvent. If it's impossible to clean, replace it. When installing the strainer on the fuel pump, use a new retainer and make sure that it's firmly seated. Before installing the fuel pump in the fuel filter housing, inspect the condition of the fuel filter inlet and outlet 0-rings. If either 0-ring is cracked, torn or deteriorated, replace it. Also make sure that the spacer at the top of the pump is in place. This spacer insures a tight fit between the pump outlet pipe and the fuel filter inlet 0-ring. If the spacer is damaged or missing, replace it. Installation is otherwise the reverse of removal, but stop when you're done installing the pump. Before installing the fuel pump access cover, reconnect the cable to the negative battery terminal, start the engine and check for fuel leaks at the pump fuel line connections. If there are no leaks, install the access cover, the carpet and the second-row seat.

Before disconnecting fuel line fittings, ensure to:1. Relieve system fuel pressure.2. Disconnect the cable from the negative battery terminal.