Honda 16400-P8F-A34 Throttle Body Assembly

To remove the throttle body, perform the following actions:1. Air intake duct: Remove the air intake duct.2. Cable bracket: Detach the cable bracket from the throttle body, while keeping the accelerator and cruise control cables attached to the bracket for their adjustment. Disconnect both cables from the throttle lever cam.3. Sensor connectors: Disconnect the electrical connector from the Manifold Absolute Pressure (MAP) sensor. On 2004 and earlier models, also disconnect the Throttle Position (TP) sensor's electrical connector.4. Coolant hoses: Loosen hose clamps, slide them back, and disconnect the coolant hoses from the throttle body. Plug the hoses to prevent further coolant loss. On 2004 and earlier models, disconnect the EVAP hose.5. Wiring: On 2004 and earlier models, disconnect the wiring from the Idle Air Control (IAC) valve. On 2005 and later models, disconnect the main wiring harness.6. Throttle body removal: Remove the two bolts and two nuts securing the throttle body to the intake manifold. Take out the throttle body, spacer, and two gaskets.