Honda 53540-T1W-A01 End Complete, Tie Rod

You can Select Your Vehicle to check if 53540-T1W-A01 fits your vehicle.

To remove the tie-rod end, loosen the wheel lug nuts, raise the front of the vehicle and support it securely on jackstands. Apply the parking brake and block the rear wheels to keep the vehicle from rolling off the jackstands, then remove the wheel. Using a back-up wrench, loosen the tie-rod end jam nut and mark the relationship of the tie-rod end to the threaded portion of the tie-rod. Remove the cotter pin and loosen the nut from the tie-rod end ballstud a few turns, then disconnect the tie-rod end ballstud from the steering arm with a puller. Remove the nut from the ballstud, separate the tie-rod end from the steering knuckle, then unscrew the tie-rod end from the tie-rod. To install the tie-rod end, thread the tie-rod end onto the tie-rod to the marked position and connect the tie-rod end to the steering arm. Install the nut on the ballstud and tighten it, then install a new cotter pin. Tighten the jam nut securely and install the wheel. Lower the vehicle and tighten the lug nuts, then have the front end alignment checked and, if necessary, adjusted.