Honda 8-94462-101-2 Flywheel

If the engine is in the vehicle, remove the clutch cover and clutch disc, or the automatic transmission. Flatten the lockplate tabs if used and remove the bolts that secure the flywheel/driveplate to the crankshaft rear flange, being cautious as the flywheel is very heavy and shouldn't be dropped. If the crankshaft turns while loosening the bolts, wedge a screwdriver in the starter ring gear teeth to prevent the flywheel from turning. Detach the flywheel/driveplate from the crankshaft flange and unbolt the engine rear plate, checking the engine block rear core plug for leakage. If the teeth on the flywheel/driveplate starter ring gear are badly worn or missing, install a new flywheel or driveplate. Clean the mating surfaces before installing the flywheel/driveplate, and if removed, reinstall the engine rear plate. Position the flywheel/driveplate against the crankshaft using a new spacer if equipped, and insert the mounting bolts with Loctite 262. Ensure the crankshaft/flywheel bolts are properly sealed to prevent oil leaks, then tighten the bolts in a criss-cross pattern to the specified torque. The remainder of the installation follows the reverse order of removal.