Honda 776A2-SB2-673ZA Seat Belt Assy., L. FR. *NH1L*(Nippon Seiko) (BLACK)

All late models are equipped with a front and rear 3-point seat belt system, while early models only have lap belts in the rear. Late model sedans also feature a power shoulder belt assembly. The 1989-91 Civic hatchback and CRX come with a 3-point belt system with components located in the door. For standard 3-point belts, except for the 1989-91 Civic hatchback and CRX, begin by removing the center door trim panel on sedan models or the quarter trim panel on hatchback models. Next, take out the upper and lower seat belt anchor bolts, followed by the retractor mounting bolts, and then remove the belt assembly from the vehicle. The center belt latch can be removed by sliding the seat forward and taking out the mounting bolt. Install the belt in position, ensuring to tighten the upper and lower anchor bolts and the retractor bolt to 23 ft. lbs. (32 Nm). After that, install the center latch assembly and bolt, tightening it to the same torque. Finally, reinstall the trim panels, ensuring the belt retracts properly. For the 1988-91 Civic hatchback and CRX, start by removing the door panel assembly, followed by the shoulder belt studs and bracket, the belt guide bolt and guide, and the nuts retaining the lap belt bracket. Remove the nuts retaining the emergency locking retractor and take out the assembly. The seat must be removed to access the center latch assembly. Reinstall the assembly in reverse order, tightening the retractor assembly bolts to 23 ft. lbs. (32 Nm), and replace the shoulder belt studs, tightening them to the same torque using a T40 Torx bit. Finally, install the door panel assembly and check that the seat belt operates properly.

First take off the center pillar trim and the front pillar trim, then take off the negative battery cable. Then, remove the seat belt track mounting bolts and the track; also, to remove the drive unit pull out the drive unit mounting bolts. Then, you should turn off the ignition and unbolt the lap belt assembly cover and the mounting bolts and finally, take out the lap belt assembly. Go further to take out the front seat assembly including the seat belt retractor assembly bolts as well as the retractor. For removal, loosen the above bolts and then unbolt the seat belt track bolts and completely remove the seat belt from installation site. To install the above, reverse the above steps and tighten the seat belt track bolts to 7 ft. lbs. (10 Nm) and the drive unit bolts to 7 ft. lbs. (10 Nm). Consult the LSA and properly install the lap belt assembly before tightening the bolts to 23 ft. lbs. The rear seat back fold bolt was the tightest at 32 NM while the seat belt assembly used bolts that were tightened to 35 ft lbs. (35 Nm). Finally adjust and fix the seat and all other interior trim panels, connect the negative terminal of the battery and inspect the functionality of the seat belt assembly. The rear lap belt is installed by pulling the belt out and removing the mounting bolts and the belt mounting bolts must be tightened to 23ft/lbs or 31Nm. (32 Nm). The rear 3-point belt is dismantled in the same manner as the front belts with the added detail that it is necessary to remove the rear quarter trim panel or C pillar panel.