Honda 37880-P0A-A02 Sensor Assembly, Air Temperature

For all models except 2008 and later with VCM proceed with the following, Pull the ignition key out of the key lock cylinder. Turn the intake manifold cover unions counter-clockwise and then lift off the intake manifold cover. Then, release the electrical connector from the Intake Manifold Temperature Sensor which is to be done by pushing on the tab on the bottom of the connector then pulling it back. Loosen and pull the Intake Manifold Temperature Sensor out, which should be done because of the low quality of the Intake Manifold Temperature Sensor O-ring. To correctly fit the Intake Manifold Temperature Sensor, one should install a new O-ring, this is regardless of whether the sensor that was initially used was retained or replaced with a new one. The procedure of installing the Intake Manifold Temperature Sensor is opposite to that of the removal and it is recommended that a new O-ring is fitted and re-tightening of the Intake Manifold Temperature Sensor is done to the right torque. For DTCS P0135 and P0141 for 1996 to 2007 models, as well as other genera related to VCM for the 2008 and later models, the Intake Manifold Temperature Sensor is incorporated with the MAF sensor.

The Intake Manifold Temperature Sensor for 2001-2002 Acura, and 2003-2004 Honda is located at the left rear corner of the intake manifold. Disengage the connector, unscrew the sensor using a wrench, and discard the old O-ring. It is on the air intake duct for 2003-2004 Acura. Disconnect the connector from it, pick up a small flat-headed screwdriver, insert it into the seam beside one end of the clip, and remove it by prying it away from the sensor before pulling out that sensor. For these two cars made in 2005-2006 and all Hondas made from 2005 onwards, you can locate it on the front side of the intake manifold near the throttle body. Remove the plug connecting to this sensor, use any adjustable wrench to loosen up its screwed part before taking off its O-ring with your fingers. MAF sensor incorporates an Intake Manifold Temperature Sensor for 2007 Acura.