Honda 42751-KEN-004 Tire (T135/80D15)

The tires should be rotated at the specified intervals and whenever uneven wear is noticed. Since the vehicle will be raised and the tires removed anyway, check the brakes at this time. Tires must be rotated in a specific pattern. For the proper procedures to follow when jacking the vehicle and changing a tire, if the brakes are to be checked, do not apply the parking brake as stated. Make sure the tires are blocked to prevent the vehicle from rolling. Preferably, the entire vehicle should be raised at the same time. This can be done on a hoist or by jacking up each corner and then lowering the vehicle onto jackstands placed under the frame rails. Always use four jackstands and make sure the vehicle is firmly supported. After rotation, check and adjust the tire pressures as necessary and tighten the wheel lug nuts. Reset the Maintenance Minder.

All vehicles described come with metric-sized steel-belted radial tires. Using other sizes or types might alter the vehicle's ride and handling. It's crucial not to mix tire types, like radials with bias-belted, since this can greatly impair handling. Ideally, replace tires in axle pairs. If only changing one tire, ensure it matches the size, structure, and tread of the other. Tire pressure significantly influences handling and wear, so check pressures monthly or before lengthy trips. Wheels that are bent, dented, leaky, have deformed bolt holes, excessive rust, lack vertical symmetry, or can't maintain tight lug nuts must be replaced. Welding or peening methods are not advised for wheel repairs. Balancing tires and wheels is vital for optimal handling, braking, and vehicle performance. Imbalanced wheels can negatively impact handling, ride experience, and tire longevity. Always balance a tire and wheel post-installation, ensuring it's done by a well-equipped shop.

Always check tire pressure when the tires are cold, meaning the vehicle hasn't been driven for over a mile in the three hours preceding the check.

All four tires should be checked, and if necessary, enough air should be added to bring them up to the recommended pressure levels.