To get to the right-side low beam bulb, use the
Headlight and
Ignition Switches turned off and open the hood. From under the hood, to the right of the right headlamp, get to the back of the assembly and unscrew the bulb socket 45 degrees counterclockwise and pull it out and separate the electrical connector. For installation reverse the above procedure as follows: For left side low beam bulb, first, the upper left hand fender trim panel should be detached, next the air intake duct cover and air intake duct which fasten with the use of inner trap door should be taken off. Twist the bulb socket to the anti clockwise or clock wise direction slightly 45 degree for disconnecting the electrical connection for the easy removing of the bulb. Once more, installation proceeds in the opposite direction to execution and is achieved in four steps. To removal the high beam bulb, turn the bulb counterclockwise 45 degrees then remove the bulb and remove the electrical connector, while to install is to reverse the process of the removal. For the CR-V, you will first have to unplug the electrical connector to the headlamp, then take off the rubber dust boot. Push the retaining bail up and slightly back to free the bulb from the fixture and take the bulb out, and the process could be done in reverse.