How to Replace the Fuel Level Sensor and Fuel Pump on a Honda Crosstour?

Relieve the fuel system pressure and remove the fuel filler neck cap to relieve any pressure inside the fuel tank, then disconnect the cable from the negative battery terminal and remove the carpeting from the floor of the trunk. Remove the fuel pump access cover screws and access cover, disconnect the electrical connector from the fuel pump/Fuel Level Sensor, disconnect the quick-connect fitting for the fuel supply line, and on non-SULEV models, remove the fuel pump/Fuel Level Sensor locknut. On SULEV models, remove the six fuel pump retaining nuts. Carefully angle the fuel pump/Fuel Level Sensor out of the tank to protect the float arm and float from damage, inspect the seal for cracks, tears and deterioration, and if it's damaged, replace it. Install a new gasket in the hole before installing the fuel pump/Fuel Level Sensor in the fuel tank, and when installing the fuel pump/Fuel Level Sensor on a non-SULEV model, make sure that the index mark on top of the fuel pump/Fuel Level Sensor is pointing between the two marks on the edge of the hole. When installing the mounting flange on a SULEV model or on a V6 model, make sure that the three asymmetrically-located notches in the mounting flange are aligned with their corresponding lugs on top of the pump assembly. Before reconnecting the fuel supply line quick-connect fitting, be sure to replace the 0-ring inside the fitting, and when installing the fuel pump/Fuel Level Sensor on an SULEV model, be sure to tighten the retaining nuts to the torque. Installation is otherwise the reverse of removal.

Genuine Honda Crosstour Fuel Pump

Gas Pump

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

10 Fuel Pumps found

View related parts
Honda Crosstour Fuel Pump Module Set
Part Number: 17045-TA0-A00
$400.24 MSRP: $577.55
You Save: $177.31 (31%)
ADD TO CART
Product Specifications
- Other Name: Fuel Pump Assembly; Fuel Pump
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2012 Honda Crosstour | 5 Door EX, 5 Door EX-L | KA 5AT
View related parts
Honda Crosstour Fuel Pump Module Set
Part Number: 17045-TP7-A00
$456.86 MSRP: $659.25
You Save: $202.39 (31%)
ADD TO CART
Product Specifications
- Other Name: Fuel Pump Assembly; Fuel Pump
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2010-2012 Honda Crosstour | 5 Door EX-L (4WD) | KA 5AT
View related parts
Honda Crosstour Fuel Pump Module Set
Part Number: 17045-TP7-A11
$383.30 MSRP: $553.10
You Save: $169.80 (31%)
ADD TO CART
Product Specifications
- Other Name: Module Set, Fuel Pump; Fuel Pump, Fuel Pump Assembly
- Replaces: 17045-TP7-A10
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2013-2015 Honda Crosstour | 5 Door EX-L (4WD) | KA 6AT
View related parts
Honda Crosstour Sub-Pump Set, Fuel
Part Number: 17049-TK5-A00
$199.16 MSRP: $283.70
You Save: $84.54 (30%)
ADD TO CART
Product Specifications
- Other Name: Fuel Pump Assembly; Fuel Pump
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2010-2015 Honda Crosstour | 5 Door EX-L (4WD) | KA 5AT, KA 6AT
View related parts
Honda Crosstour Fuel Pump Module Assembly
Part Number: 17045-TK4-A00
$430.08 MSRP: $620.60
You Save: $190.52 (31%)
ADD TO CART
Product Specifications
- Other Name: Fuel Pump Assembly; Fuel Pump
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2010-2012 Honda Crosstour | 5 Door EX (2WD), 5 Door EX-L (2WD) | KA 5AT
View related parts
Honda Crosstour Fuel Pump Module Set
Part Number: 17045-TY4-A11
$383.30 MSRP: $553.10
You Save: $169.80 (31%)
ADD TO CART
Product Specifications
- Other Name: Module Set, Fuel Pump; Fuel Pump, Fuel Pump Assembly
- Replaces: 17045-TY4-A10
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2013-2015 Honda Crosstour | 5 Door EX, 5 Door EX-L | KA 5AT
View related parts
Honda Crosstour Fuel Pump Module Set
Part Number: 17045-TP7-A10
$383.30 MSRP: $553.10
You Save: $169.80 (31%)
ADD TO CART
Product Specifications
- Other Name: Fuel Pump Assembly
- Replaced by: 17045-TP7-A11
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2013-2015 Honda Crosstour | 5 Door EX-L (4WD) | KA 6AT
View related parts
Honda Crosstour Fuel Pump Module Set
Part Number: 17045-TY2-A01
$432.67 MSRP: $624.35
You Save: $191.68 (31%)
ADD TO CART
Product Specifications
- Other Name: Module Set, Fuel Pump; Fuel Pump, Fuel Pump Assembly
- Replaces: 17045-TY2-A00
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2013-2015 Honda Crosstour | 5 Door EX (2WD), 5 Door EX-L (2WD) | KA 6AT
View related parts
Honda Crosstour Fuel Pump Module Set
Part Number: 17045-TY2-A00
$432.67 MSRP: $624.35
You Save: $191.68 (31%)
ADD TO CART
Product Specifications
- Other Name: Fuel Pump Assembly
- Replaced by: 17045-TY2-A01
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2013-2015 Honda Crosstour | 5 Door EX (2WD), 5 Door EX-L (2WD) | KA 6AT
View related parts
Honda Crosstour Fuel Pump Module Set
Part Number: 17045-TY4-A10
$383.30 MSRP: $553.10
You Save: $169.80 (31%)
ADD TO CART
Product Specifications
- Other Name: Fuel Pump Assembly
- Replaced by: 17045-TY4-A11
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2013-2015 Honda Crosstour | 5 Door EX, 5 Door EX-L | KA 5AT

Honda Crosstour Fuel Pump

In particular, the Fuel Pump in Honda Crosstour vehicles is one of the most important component that has the responsibility of pumping fuel from the tank to the carburetor or the fuel injector system. Continuously variable hydraulic pumps can be used in fuel injection systems and mechanically operated hydraulic lift pumps are used in carburetor systems. Its purpose is to force the fuel, as well as clean it, so as to enhance the combustion system in the engines. There are differences in the fuel pumps of the Honda Crosstour cars; the electrical ones are usually located interior to the tank, while the mechanical ones are externally placed. Electric pumps provide higher pressure ranges and its on vehicles are provided with electronic control for metering of fuel and safety check. Altogether, the Fuel Pump plays an important role of delivering an accurate fuel quantity and pressure which improves the performance and horsepower needed in Honda Crosstour automobiles.

In search of affordable OEM Honda Crosstour Fuel Pump? Consider browsing through our extensive inventory of genuine Honda Crosstour Fuel Pump. Not only do we provide market-leading prices and a manufacturer's warranty, but we also pride ourselves on exceptional customer service and swift delivery.

Honda Crosstour Fuel Pump Parts Questions & Experts Answers

Sub-Pump Set, Fuel
17049-TK5-A00
Q: How to Replace the Fuel Level Sensor and Fuel Pump on a Honda Crosstour?
A:
Relieve the fuel system pressure and remove the fuel filler neck cap to relieve any pressure inside the fuel tank, then disconnect the cable from the negative battery terminal and remove the carpeting from the floor of the trunk. Remove the fuel pump access cover screws and access cover, disconnect the electrical connector from the fuel pump/Fuel Level Sensor, disconnect the quick-connect fitting for the fuel supply line, and on non-SULEV models, remove the fuel pump/Fuel Level Sensor locknut. On SULEV models, remove the six fuel pump retaining nuts. Carefully angle the fuel pump/Fuel Level Sensor out of the tank to protect the float arm and float from damage, inspect the seal for cracks, tears and deterioration, and if it's damaged, replace it. Install a new gasket in the hole before installing the fuel pump/Fuel Level Sensor in the fuel tank, and when installing the fuel pump/Fuel Level Sensor on a non-SULEV model, make sure that the index mark on top of the fuel pump/Fuel Level Sensor is pointing between the two marks on the edge of the hole. When installing the mounting flange on a SULEV model or on a V6 model, make sure that the three asymmetrically-located notches in the mounting flange are aligned with their corresponding lugs on top of the pump assembly. Before reconnecting the fuel supply line quick-connect fitting, be sure to replace the 0-ring inside the fitting, and when installing the fuel pump/Fuel Level Sensor on an SULEV model, be sure to tighten the retaining nuts to the torque. Installation is otherwise the reverse of removal.

Related Honda Crosstour Parts

Browse by Year

2015 Fuel Pump 2014 Fuel Pump 2013 Fuel Pump 2012 Fuel Pump 2011 Fuel Pump 2010 Fuel Pump