How to Remove the Windshield Wiper Blade,Washer Pump and Arm on Honda Prelude?

To remove the windshield wiper blade and arm, remove the mounting nut from the wiper pivot, press down on the arm, and fold it up. For the rear wiper arm, use a 12mm wrench. To remove the wiper motor, make sure the wipers are in the park position, remove the arms, clips, and trim covers, then use a 10mm socket to remove the four mounting bolts. To remove the washer pump, remove the bumper or fender well, disconnect the motor and fluid hose, and release the pump from the bottle and grommet. To reinstall, switch the removal steps going from the final step to the first step.

Genuine Honda Prelude Washer Pump

Windshield Washer Pump

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

6 Washer Pumps found

View related parts
Honda Prelude Motor, Washer (Mitsuba)
Part Number: 38512-SF0-J01
$49.36 MSRP: $69.72
You Save: $20.36 (30%)
ADD TO CART
Product Specifications
- Other Name: Front Washer Pump; Rear Washer Pump, Washer Pump
- Replaces: 38512-SF0-013, 38512-SF0-003
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 1985-1987 Honda Prelude | 2 Door DX, 2 Door SI | KA 4AT, KA 5MT, KL 4AT, KL 5MT
View related parts
Honda Prelude MOTOR, WASHER
Part Number: 76806-T24-T01
$25.92 MSRP: $36.62
You Save: $10.70 (30%)
ADD TO CART
Product Specifications
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2026 Honda Prelude | 2 Door Hybrid Direct Drive Unit, 2 Door Hybrid Two-Tone Direct Drive Unit | CVT
View related parts
Honda Prelude Motor, Washer (Front)
Part Number: 76806-SE0-N01
Product Specifications
- Other Name: Washer Reservoir; Washer Pump
- Position: Front
- Replaces: 38512-SA5-981, 76806-SE0-003, 76806-SE0-S01
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 1988-2001 Honda Prelude | 2 Door 2.05SI, 2 Door 2.0S, 2 Door 2.0SI, 2 Door Base, 2 Door S, 2 Door SI, 2 Door Sivtec, 2 Door TYPESH | KA 4AT, KA 5MT, KL 4AT, KL 5MT
View related parts
Honda Prelude Motor, Washer
Part Number: 38512-SB0-003
Product Specifications
- Replaced by: 38512-SB0-013
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 1983-1985 Honda Prelude | 2 Door DX | KA 4AT, KA 5MT, KH 4AT, KH 5MT, KL 4AT, KL 5MT
View related parts
Honda Prelude Motor, Washer
Part Number: 38512-679-013
Product Specifications
- Replaced by: 38512-679-023
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 1979-1982 Honda Prelude | 2 Door ** | KA 5MT, KA HMT, KH 5MT, KH HMT, KL 5MT, KL HMT
View related parts
Honda Prelude Motor, Washer
Part Number: 38512-679-003
Product Specifications
- Replaced by: 38512-679-023
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 1979-1981 Honda Prelude | 2 Door ** | KA 5MT, KA HMT, KH 5MT, KH HMT, KL 5MT, KL HMT

Honda Prelude Washer Pump

The Honda Prelude Washer Pump works by forcing washer fluid from the reservoir to the nozzles, which in turn gives drivers the ability to clean the windshield and view the road ahead. Mounted low on the tank, the compact electric motor in this Washer Pump rotates an impeller each time the wiper switch is pressed to push fluid through thin hoses until it sprays across the glass. Across all Prelude generations, there was little change in the design, moving from a simple two-wire plug to a later sealed connector, but each Washer Pump is still based on twelve-volt power and simple pressure in order to function. There are no alternative vacuum or gear-drive versions, so a fourth-generation model, the Honda Prelude, uses the same style as years past and swaps in without any additional brackets. Failure often shows up as dry wipers or a soft hum without any spray, and replacing the Washer Pump is generally affordable, with labor adding a modest additional expense for Honda owners. Every Honda Prelude is ready for rain, dust, and bugs, and one healthy Prelude Washer Pump has got you covered and ready for a clear view in seconds.

In search of affordable OEM Honda Prelude Washer Pump? Consider browsing through our extensive inventory of genuine Honda Prelude Washer Pump. Not only do we provide market-leading prices and a manufacturer's warranty, but we also pride ourselves on exceptional customer service and swift delivery.

Honda Prelude Washer Pump Parts Questions & Experts Answers

Motor, Washer (Front)
76806-SE0-N01
Q: How to Remove the Windshield Wiper Blade,Washer Pump and Arm on Honda Prelude?
A:
To remove the windshield wiper blade and arm, remove the mounting nut from the wiper pivot, press down on the arm, and fold it up. For the rear wiper arm, use a 12mm wrench. To remove the wiper motor, make sure the wipers are in the park position, remove the arms, clips, and trim covers, then use a 10mm socket to remove the four mounting bolts. To remove the washer pump, remove the bumper or fender well, disconnect the motor and fluid hose, and release the pump from the bottle and grommet. To reinstall, switch the removal steps going from the final step to the first step.