Honda 52360-SH3-G11 Arm, Left Rear (Lower)

Loosen the front wheel lug nuts, raise the vehicle, place it securely on jackstands, and remove the wheel. Detach the stabilizer bar from the lower control arm. Detach the damper fork from the shock absorber. Remove the cotter pin from the castle nut on the lower balljoint stud, loosen the nut without removing it, and use a puller to separate the lower control arm from the balljoint in the steering knuckle before removing the nut. Remove the pivot bolt from the inner end of the lower control arm and separate the arm from the chassis. Remove the nut from the rear pivot stud, pull the stud out of the bushing, and remove the arm, noting that it's not necessary to remove the three bushing clamp retaining bolts unless the bushing is to be replaced. Installation is the reverse of removal.

Check the bushings at each end of the control arm and the arm itself for any damage or wear.

Connect the radius bar to the control arm and tighten the bolts to 80 ft. lbs. (110 Nm), then tighten the lower control arm to chassis bolt to 43 ft. lbs. (60 Nm) and connect the damper fork to the control arm, tightening the bolt to 47 ft. lbs. (65 Nm).

Installation follows the reverse order of removal, ensuring all fasteners are tightened to the specified torque values.