Honda 11910-P30-000 Bracket, Engine Mount

Engine mounts seldom require attention, but broken or deteriorated mounts should be replaced immediately to prevent damage or wear on driveline components. To check the mounts, raise the engine slightly to remove the weight from them. Begin by raising the vehicle and securely supporting it on jackstands, then position a jack under the engine oil pan with a large wood block in between. Carefully raise the engine just enough to relieve the weight on the mounts. Inspect the mount insulators for any cracks, hardened rubber, or separation from the metal plates, noting that the rubber may split down the center. Check for any relative movement between the mount plates and the engine or frame using a large screwdriver or pry bar; if movement is detected, lower the engine and tighten the mount fasteners. Applying rubber preservative to the insulators can help slow deterioration. For replacement, disconnect the battery cable from the negative terminal, ensuring you have the correct activation code for any anti-theft radio system. Raise the vehicle and support it securely on jackstands, then support the engine. Remove the fasteners, raise the engine with the jack, and detach the mount from the frame bracket and engine. Install the new mount, ensuring it is correctly positioned in its bracket, and then install and securely tighten the fasteners.