Honda 39120-SV4-A01 Speaker Assembly (6 1/2") (Single Cone)

The stereo in your vehicle may be equipped with an anti-theft system; ensure to check the relevant information before detaching the battery cables. To remove the stereo, first detach the cable from the negative terminal of the battery, followed by the positive cable. Next, remove the center console, then reach under the radio to remove the two retaining screws. Pull out the stereo, unplug the electrical connector and antenna lead, and then remove the unit. Installation is the reverse of removal. For front speakers, start by removing the door trim panel, then take out the speaker mounting screws, pull out the speaker, and unplug the electrical connector. Installation is again the reverse of removal. For rear speakers in a coupe, open the trunk, remove the nuts and clips, and detach the trim panel between the seat back and the rear window. Inside the vehicle, remove the screws and lift the speaker and adapter out as an assembly. In a sedan, work in the trunk to remove the speaker grill nuts and unplug the wires from the speaker, then inside the vehicle, remove the screws, detach the speaker, and lift it out. Installation is the reverse of removal.

Note the radio security code, then disconnect the negative battery cable.Remove the center console.Detach the cup holder (if applicable).Remove the mounting bolts/screws from the console.Remove the mounting screws from the radio and then pull the unit out slightly for access to the connectors on the rear of the radio.Detach the connectors and antenna lead, then remove the radio from the vehicle.Installation is the reverse of the removal procedure. Once installed, enter the security code.SpeakersREMOVAL & INSTALLATION: If necessary, remove the door panel.Locate the small rectangular opening at the bottom of the speaker grilles.Using a suitable, small flat blade pry tool, carefully pry the speaker grille up.Remove the Phillips screws that mount the speaker.Carefully remove the speaker from the door panel, instrument panel or rear deck to gain access to the electrical connector.Remove the wire connector from the speaker, then remove the speaker from the vehicle.Installation is the reverse of the removal procedure.