Honda 17910-S9V-A82 Throttle Wire

On all 2005 and later Honda vehicles and 2003 through 2006 Acura models, the throttle body works through an electric servo motor driven by the engine control computer, replacing the standard cable connection. With these cars, a cable runs from the gas pedal to an APP sensor on the firewall. This sensor sends an electrical voltage reading to the PCM to show how much you press the pedal. Unplug the battery, take off the bolts that hold the sensor cover, and lift it off. With the throttle cam turned counterclockwise to its widest opening, take the cable off the cam, unscrew the locknut from the cable end, and pull the cable out of its bracket. Find the cable connection on top of the pedal, push the pedal all the way forward to pull the cable loose from its attachment point on the pedal arm. Locate the wire planned for the firewall, turn the mounting bracket face downwards, and remove the cable systems into the passenger space using your hand. Reinstall by reversing your steps, and make sure to check and adjust the accelerator cable when fixing the cover back into place. Push down on the accelerator cable till the throttle cam is closed, note the cable swing. Turn your adjustment nut until the deflection error changes. When you finish, ask another person to push the accelerator stick all the way down to ensure everything opens fully, then checks that everything returns to the standard neutral setting when the accelerator gets released.

In these models, which have an electronic throttle body without a conventional accelerator cable, follow these steps: 1.Disconnect the cable from the negative battery terminal. 2.Remove the Accelerator Pedal Position (APP) sensor cover bolts and the cover. 3.Rotate the throttle lever cam counterclockwise and disengage the cable. 4.Loosen the accelerator cable locknut at the bracket and disengage it. 5.Locate the cable connection beneath the dash, push the pedal's upper end forward, and disengage the cable. 6.Trace the cable to the firewall, rotate the retainer counterclockwise, and pull the cable assembly through. 7.For adjustment, with the throttle cam closed, measure cable deflection between the bracket and cam. Adjust if necessary, ensuring the throttle cam opens fully when the pedal is depressed and returns to its closed position. 8.Install the cover when finished.