There are two ECT sensors, the first is located in the cylinder head, facing the firewall, towards the driver's side of the engine, while the second is found at the right end of the lower radiator tank. Begin by draining the coolant from the engine. For the first sensor, remove the air filter housing, and if working on a 2009 or later model, take out the bolt securing the hose bracket at the left end of the cylinder head and move the hose aside for access. Disconnect the electrical connector from the first ECT sensor, then unscrew it from the cylinder head. Installation involves reversing the removal steps, ensuring a new O-ring is used and the sensor is tightened to the specified torque. Afterward, refill the cooling system. For the second sensor, raise the vehicle and support it securely on jackstands, then disconnect the electrical connector from the sensor located in the radiator lower tank. Unscrew the sensor from the radiator tank, and similarly, installation is the reverse of removal, using a new O-ring and tightening to the specified torque before refilling the cooling system.