How to replace the Headlight Switch,Turn Signal Switch and Wiper Switch on Honda Ridgeline?

To begin the removal process for safety reasons, firstly disconnect the cable from the negative terminal on the battery and wait for at least 3 minutes before proceeding. Next, remove both upper and lower steering column covers including knee bolster. To remove the headlight switch, high beam/low beam switch and turn signal switch which make up multi-function switch, disconnect its electrical connectors from the switch and take out retaining screws. Finally prise apart the little pad on a small lug of a key way by means of careful fingers to get into a position where you can yank it out; after that you will have to pull out this very item which is called "a wiper/washer switch". The procedure for removing a wiper/washer switch involves an electrical connector removal, taking off retaining screws as well as prying away housing from that small pad on top of such device until it finally comes out. In addition to that, steering wheel together with airbag clockspring must be removed in order to access combination switch assembly containing multifunction switches as well as wiper/washer switches. Disconnect all wires from multifunction switches as well as windshield wiper/washer switches and combination switch. Then unclip airbag electrical harness from small bracket located at left side of key lock cylinder/ignition switch housing by pulling clip towards rear of vehicle; also disconnect big yellow connector attached to airbag harness. Remove mounting screws(3)and combination switch assembly from steering column. This is done in reverse order during installation.

Genuine Honda Ridgeline Wiper Switch

Windshield Wiper Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

4 Wiper Switches found

View related parts
Honda Ridgeline Wiper Switch Assembly
Part Number: 35256-TV0-S61
$41.04 MSRP: $57.97
You Save: $16.93 (30%)
ADD TO CART
Product Specifications
- Other Name: Wiper Switch
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2017-2018 Honda Ridgeline | 4 Door Black, 4 Door RT (2WD), 4 Door RT (AWD), 4 Door RTL, 4 Door RTL (2WD), 4 Door RTL (AWD), 4 Door RTS (2WD), 4 Door RTS (AWD), 4 Door Sport (2WD), 4 Door Sport (AWD) | KA 6AT
View related parts
Honda Ridgeline Wiper Switch Assembly
Part Number: 35256-SJC-A01
$88.85 MSRP: $125.50
You Save: $36.65 (30%)
ADD TO CART
Product Specifications
- Other Name: Wiper Switch
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2006-2008 Honda Ridgeline | 4 Door RT, 4 Door RTL, 4 Door RTS, 4 Door RTX | KA 5AT
View related parts
Honda Ridgeline Wiper Switch Assembly
Part Number: 35256-SJC-A02
$151.73 MSRP: $216.13
You Save: $64.40 (30%)
ADD TO CART
Product Specifications
- Other Name: Wiper Switch
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2009-2014 Honda Ridgeline | 4 Door RT, 4 Door RTL, 4 Door RTS, 4 Door Sport | KA 5AT
View related parts
Honda Ridgeline Wiper Switch Assembly
Part Number: 35256-TVA-A11
$37.64 MSRP: $53.17
You Save: $15.53 (30%)
ADD TO CART
Product Specifications
- Other Name: Switch Assembly, Wiper; Wiper Switch
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2019-2026 Honda Ridgeline | 4 Door Black, 4 Door Black Edition, 4 Door Black Edition AWD, 4 Door Black Edition Two-Tone, 4 Door RT (2WD), 4 Door RTL, 4 Door RTL (2WD), 4 Door RTL (AWD), 4 Door RTL AWD, 4 Door RTL-E AWD, 4 Door Sport, 4 Door Sport (2WD), 4 Door Sport (AWD), 4 Door Sport AWD, 4 Door TrailSport, 4 Door TrailSport AWD, 4 Door TrailSport With HPD Wheels | 9AT, KA 6AT, KA 9AT

Honda Ridgeline Wiper Switch

The Honda Ridgeline Wiper Switch allows drivers to immediately start and adjust the speed of the truck's windshield wipers to keep the glass clear for safe road vision in rain, snow, or spray. This Wiper Switch is located in easy reach on the steering column so that the driver can flick the switch up or down to select intermittent, low, or high sweeps without taking their attention from traffic. Inside the switch housing are simple electrical contacts that snap closed and route power to the wiper motor, converting a light finger movement to sustained blade movement corresponding to the intensity of the weather. Across every Honda Ridgeline generation, the Wiper Switch has had the same basic function of activating and controlling speed, and the quoted piece mentions no alternative styles, which means that owners encounter the same familiar layout year after year. Because visibility is directly controlled, Honda designed each Ridgeline Wiper Switch to respond so well that even a gentle tap is answered with the just-right rhythm to answer a storm. Regular use of the Wiper Switch in any Honda Ridgeline maintains clear sightlines and increases driver confidence when driving both day and night.

In search of affordable OEM Honda Ridgeline Wiper Switch? Consider browsing through our extensive inventory of genuine Honda Ridgeline Wiper Switch. Not only do we provide market-leading prices and a manufacturer's warranty, but we also pride ourselves on exceptional customer service and swift delivery.

Honda Ridgeline Wiper Switch Parts Questions & Experts Answers

Wiper Switch Assembly
35256-SJC-A02
Q: How to replace the Headlight Switch,Turn Signal Switch and Wiper Switch on Honda Ridgeline?
A:
To begin the removal process for safety reasons, firstly disconnect the cable from the negative terminal on the battery and wait for at least 3 minutes before proceeding. Next, remove both upper and lower steering column covers including knee bolster. To remove the headlight switch, high beam/low beam switch and turn signal switch which make up multi-function switch, disconnect its electrical connectors from the switch and take out retaining screws. Finally prise apart the little pad on a small lug of a key way by means of careful fingers to get into a position where you can yank it out; after that you will have to pull out this very item which is called "a wiper/washer switch". The procedure for removing a wiper/washer switch involves an electrical connector removal, taking off retaining screws as well as prying away housing from that small pad on top of such device until it finally comes out. In addition to that, steering wheel together with airbag clockspring must be removed in order to access combination switch assembly containing multifunction switches as well as wiper/washer switches. Disconnect all wires from multifunction switches as well as windshield wiper/washer switches and combination switch. Then unclip airbag electrical harness from small bracket located at left side of key lock cylinder/ignition switch housing by pulling clip towards rear of vehicle; also disconnect big yellow connector attached to airbag harness. Remove mounting screws(3)and combination switch assembly from steering column. This is done in reverse order during installation.